Не работает подогрев. Предохранитель живой. Стекло целое.
Там еще реле в цепочке есть, правда оно похоже встроенное в блок предохранителей. Кроме того он работает только при заведенном двигателе.
P.S. А он у тебя вообще работал, а то у маджентисов есть комплектации в которых он отсутствует, хотя кнопка на панели есть
1. Disconnect the negative (-) battery terminal.
2. Remove the center facia panel(B) by using a scraper(A). Take care of fixing clip.
3. Disconnect the connectors.
4. Using an ohmmeter, inspection the continuity between the terminals after removing to the switch connector.
1. Disconnect the negative (-) battery terminal.
2. Remove the junction box.
3. Check for continuity between the terminals.
4. There should be continuity between the No.2 in the I/P-G and No.8 terminal in the I/P-K when power and ground are connected to the No.2 terminal in the I/P-G and No.8 terminal in the I/P-C.
5. There should be no continuity between the No.2 terminal in the I/P-G and No.8 terminal in the I/P-K when power is disconnected.